I am using the Adafruit servo library and am following the installation and use instructions found here. I encountered few errors in the installation and attempted to run it with a servo. I attached a Li-Po battery with an eliminator circuit that outputs 5V and 3A of current which matches the draw of the needs of the servo driver. I measured the voltage across the positive and negative leads of the servo and found it to be 5 volts, which matches the needs of the servo. I then connected the matching pins based on the instructions using jumper wires. |
img-2548__2_.mov | |
File Size: | 7985 kb |
File Type: | mov |